Page 1 of 1

Output signal to serial or parallel port?

PostPosted: Sun Nov 27, 2011 12:46 am
by gjvo
Hello, your program seems to works great.
I am testing with it now but i was wondering if it is possible when motion is detected to send a signal to the parallel or serial port?
So, instead of a sound, a high or low output direct to a port.
For us the time between detecting the motion and an outputsignal must be as short as possible.
We want to use it as a sort of photogate for modelplanes.

Thank you!

GJ

Re: Output signal to serial or parallel port?

PostPosted: Sun Nov 27, 2011 8:56 am
by Administrator
Sounds like you already have an utility that sends signal via parallel or serial to your equipment.
In this case you can use "Run program" Destination - to execute your utility and send a signal on a motion detected.

Re: Output signal to serial or parallel port?

PostPosted: Sun Nov 27, 2011 10:24 am
by gjvo
Thanks for your answer.
We don't have a program that gets a signal from a port, but i just need a fast switching signal.
But you gave me an idea, i can write a script that is executed by the motion.
Thanks!

Gert-Jan