Page 1 of 1

Motion Detector Selection

PostPosted: Fri Jul 29, 2016 12:30 am
by racerfern
I have the registered lite version and at times one or two of the four cameras stops recording because it appears there is no image in the motion detection mini-screen. I have red for detection but white elsewhere. At that point recording stops. I've deleted various cameras but the issue keeps reoccurring. Suggestion? BTW, It's various cameras not the same camera.

Re: Motion Detector Selection

PostPosted: Sun Aug 07, 2016 10:49 am
by racerfern
As a follow-up, this continues to happen. Restarting the Xeoma viewing app tends to clear the problem though it will eventually return on one of the cameras.

I do notice that when this happens, the little corner picture in the upper right corner of the Motion Detector Module is completely blank as if it's not even supposed to be there. As I type this all of the cameras are working but I will supply a screenshot when it happens again.

Any ideas anyone?

Re: Motion Detector Selection

PostPosted: Fri Aug 12, 2016 12:14 am
by racerfern
Today it happened on three of the four cameras. This is getting frustrating.

Surely I can't be the only one that has ever seen this.

Suggestions appreciated.