Motion search question

Xeoma Software

Moderators: Admin_N, Administrator, Admin_P, Admin_K

Motion search question

Postby Nonyaz » Sat Sep 10, 2016 1:47 am

Does the motion search area have to be in the original motion search area used to record?

I have a video with a busy street in the top half of the video, and I have that area highlighted to record motion. The bottom half is my yard with no motion. While watching the recording I noticed a cat in my yard and wanted to do a search on it. I selected the area I know the cat was and it search really fast and with no results. Is this because the bottom half was not in the original search area?
Nonyaz
 
Posts: 2
Joined: Sat Sep 10, 2016 1:43 am

Re: Motion search question

Postby XeoMax » Wed Sep 14, 2016 4:54 pm

You need to set the motion detection area on your yard and increase the sensitivity, then xeoma will catch your cat when it moves again in your yard.
Xeoma does a wonderful job in search for motion and it is the fastest software i've ever seen.
XeoMax
 
Posts: 43
Joined: Fri Apr 08, 2016 2:59 pm

Re: Motion search question

Postby Admin_P » Thu Sep 15, 2016 7:47 am

Hello! Yes, in order to do a motion search within a certain area, this area has to be within the motion detector's range. You can set a single detector to watch several different spots on a single camera, if you so desire.
Admin_P
 
Posts: 245
Joined: Wed Aug 24, 2016 1:49 pm


Return to Xeoma - General discussion

Who is online

Users browsing this forum: No registered users and 4 guests

cron