Felenasoft

I have been evaluating the product for 4 security csameras There seem to be a lack of instructions but it is fairly easy to figure out

what I have done is point all four camera to wone port so I can view on one page

xxxxx.dyndns.org

the most I can get to view at one time is three never all four is this a limitation of an unlincsed copy??

would appreciate a response from the support people

The trial version which I believe you are using doesn't have limitation in number of sources or cameras so apparently it's not that.

First of all, please go to the Web Server module settings of all cameras and check this number there:



This number must be unique for each stream (for each camera and consequently each web server module). Change the number there to a unique value if there are several Web Server Modules using the same number.

Now, at this very moment I can't see any image in web server you provided a link to. Is it working right now?

the server is running and thenumbers are unique

Most probably you connected Web Server after Motion Detector, so when there's no motion in the field of view, Web Server of this camera shows nothing. Please check your modules' settings.If you need continuous broadcasting, please reconfigure the chain to let Web Server get image continuously.

that was it thanks!!!