Foscam FI8910W PTZ Control

Xeoma Software

Moderators: Admin_N, Administrator, Admin_P, Admin_K

Foscam FI8910W PTZ Control

Postby mpphilli » Fri May 06, 2016 5:49 pm

Hi,

I am trying to setup a Foscam FI8910W. Xeoma is able to find and add the camera only if it is set to its default settings. If I log into the camera and setup the username and password Xeoma no longer is able to connect to it. Also, when Xeoma is connected to the camera the PTZ capabilities of the camera are not available.

Any Help would be greatly appreciated.
Thanks,
Mike
mpphilli
 
Posts: 1
Joined: Sat Apr 23, 2016 3:21 pm

Re: Foscam FI8910W PTZ Control

Postby Admin_M » Tue May 10, 2016 3:00 pm

Hi Mike!

Please, contact our tech support. The direct access to your camera may be needed to be able to fix the issue.
Admin_M
 
Posts: 72
Joined: Thu Jun 20, 2013 11:14 am

Re: Foscam FI8910W PTZ Control

Postby Markgas » Thu May 26, 2016 5:31 pm

I had this same problem.

I changed the "rtsp://" to "http://" in the stream settings of the camera.

for example "rtsp://192.168.1.5:88/videoMain" was changed to "http://192.168.1.5:88/videoMain"

Xeoma then recognised the PTZ controls under the use PTZ control selection , then I went back into the stream settings of the camera and changed it back to "rtsp://"
Attachments
Screen Shot 2016-05-26 at 7.28.02 PM.png
Screen Shot 2016-05-26 at 7.28.02 PM.png (248.44 KiB) Viewed 9068 times
Markgas
 
Posts: 1
Joined: Thu May 26, 2016 5:19 pm

Re: Foscam FI8910W PTZ Control

Postby Admin_N » Fri May 27, 2016 12:35 pm

Thanks for your advice, Markgas!

That's right, if PTZ commands weren't detected for your camera's URL, try another (from the dropdown list of found URLs in Universal Camera, or from camera's manual). That might help
Admin_N
 
Posts: 799
Joined: Thu Mar 01, 2012 4:43 pm


Return to Xeoma - General discussion

Who is online

Users browsing this forum: No registered users and 5 guests